Summary:ASTERISK-08398: System failed to detect analog ports
Reporter:Andrew Payne (payne92)Labels:
Date Opened:2006-12-19 20:52:09.000-0600Date Closed:2006-12-26 15:11:43.000-0600
Versions:Frequency of
Description:The system failed to detect installed analog ports (TDM 400P):

- In the setup wizard
- In the service providers setup
- In users, allowing an option to assign users to an analog line

At boot time, the system reported finding the Digium hardware.


AsteriskNOW + GUI build as of 6pm 19-Dec-2006
Comments:By: Andrew Payne (payne92) 2006-12-19 20:59:54.000-0600

Here's the tail end of 'dmesg' output from the test system, showing the probe of the Digium card that's installed:

... CUT ...

Zapata Telephony Interface Registered on major 196
Zaptel Version: 1.4.0-beta3 Echo Canceller: MG2
Registered Tormenta2 PCI
ACPI: PCI Interrupt 0000:00:08.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11
Freshmaker version: 73
Freshmaker passed register test
Module 0: Installed -- AUTO FXS/DPO
Module 1: Installed -- AUTO FXS/DPO
Module 2: Installed -- AUTO FXO (FCC mode)
Module 3: Installed -- AUTO FXO (FCC mode)
Found a Wildcard TDM: Wildcard TDM400P REV I (4 modules)
usbcore: registered new driver wcusb
Wildcard USB FXS Interface driver registered
Registered tone zone 0 (United States / North America)
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
eth0: no IPv6 routers present
Zaptel Transcoder support loaded

By: Pari Nannapaneni (pari) 2006-12-20 16:59:36.000-0600

This has been fixed and the next version of asterisk now
should work fine.

Request: can you add AsteriskNOW specific issues under AsteriskNOW
and not under GUI.